Manual Control Double Disc Refiner , Hydraulic Pressure Paper
Pulper Machine
Description:
The refiner has two kinds: conical refiner and double disc refiner.
Conical refiner is a new type pulping equipment through our own
research and development. It can not only auto level (devillicate
and broom) all kinds of pulp (including wood pulp, cotton pulp and
paper pulp) but also improve the degree of beating. It can make the
pulp to match the requirements of paper machine. It can be used
single or multi series.
The double disc refiner has two refining sections. The area it
needs is small, and production efficiency is high, power
consumption is low, and operating maintenance is easy. According to
process requirements, the refiners can be used in series and in
parallel, which is the ideal beating equipment.
Features of conical refiner:
It’s easier to repair and replacement grinding
The consumed power of no-load operation is low.
The water and pulp stay in the pulping area for long time, so the
quality of fiber will be very good.
If the cone contacts well, the efficiency will be high
It has degritting which can clean the slurry and reduce the damage
of cutter.
Features of conical refiner:
It adopts door structure to make it convenient to replace the
grinding.
It adopts hydraulic pressure to adjust the clearance of grinding.
It can adopt manual control, constant power control and constant
power control
It has special balancing mechanism
Technical parameter:
Pulp amount: 15~500t/d
Pulp concentration: 2~6%
Pressure: 0.1~0.2MPa
Inlet diameter: 200~300mm
Outlet diameter: 150~250mm
Structure chart
1. Left body
2. Cutting disc
3. Rotator
4. Movable base
5. Right body
6. Hydraulic feed components
7. Inlet pipe
8. Shaft seal parts
9. Bearing parts
10. Shaft
